Chiwai Chan's Blog

These words are my own

FeedMyFurBabies – Send and Receive MQTT messages between AWS IoT Core and your micro-controller – I am switching from Arduino CPP to MicroPython

My usual rant on what I am trying to achieve in a blog Recently I switched my Cat Feeder project’s IaC to AWS CDK in favour of increasing my focus and productivity on building and iterating, rather than constantly mucking around with infrastructure everytime I resume my project after a break; which is rare and […]

FeedMyFurBabies – I am switching to AWS CDK

I am switching to AWS CDK I have been a bit slack on this Cat Feeder IoT project for the last 12 months or so; there have been many challenges I’ve faced during that time that prevented me from materialising the ideas I had – many of them sounded a little crazy if you’ve had […]

FeedMyFurBabies – Event-Sourcing using Amazon EventBridge

Introduction In my previous AWS IoT Cat feeder project I used a Lambda function as the event handler each time the Seeed Studio AWS IoT 1-click button was pressed, the Lambda function in turn published an MQTT message to AWS Iot Core which is received by the Cat Feeder (via a Seeed Studio XIAO ESP32C3 […]

4×4 fun with a bit of Iot, vlogging and Machine Learning – Part 1

4×4 fun with a bit of Iot, vlogging and Machine Learning – Part 1 Months prior to the very first lockdown I had gotten myself on the waitlist for a 4×4 Jimny, so I could take it to the beach without worrying about getting beached like I likely would in a regular front wheel drive […]

Feed My Fur Babies – AWS Amplify and Route53

New Blog Series – AWS Amplify I’m starting a new blog series where I will be documenting my build of a full-stack Web and Mobile application using AWS Amplify to implement both the frontend, as well as the backend; whilst developing dependent downstream Services outside of Amplify using AWS Serverless components to implement a Micro-Service […]

Smart Cat Feeder – Part 4

This is the Part 4 and final blog of the series where I detail my journey in learning to build an IoT solution. Please have a read of my previous blogs to get the full context leading up to this point before continuing. Part 1: I talked about setting up a Seeed AWS IoT Button […]

Smart Cat Feeder – Part 3

In this Part 3 of the blog series I talk about my experience printing objects using a 3D Printer for the first time. In Part 1, I talked about setting up an IoT Button; and in Part 2, I talked about publishing events to an Adruino Micro-controller from AWS. After putting in the hard work […]

Scroll to top